GDM-8261(A) Remote Viewer Guide
14
Configuration
1. Configure the
PC
1. To make sure the DMM is recognized by the PC,
open the Device Manager (Start > Control
Panel > (System) > Device Manager. If using
USB, the USB driver, GDM8261(A) CDC, should
be listed in the Ports section.
2. Check which COM port the USB driver/RS232
connection is assigned to.
3. Please note the COM port number for the PC
connection.
2. Configure DMM
Viewer
1. Activate DMM Viewer.
2. Click on the Setting(O)
menu and open the settings
dialog. Enter the default
settings as detailed below. For
more information on
configuring Sample Rate and
Recording, see the
measurement chapter on
page 16.
• COM PORT: according to the Device Manager
• Baud Rate: 115200 (Or the baud rate set above)
3. Click on the Connect button. The viewer software
and the GDM-8261(A) will try to establish a
connection (success), or an error message appears
(fail). If the connection is successful, a pop-up
message will return the model type, serial number
and firmware version.
Commentaires sur ces manuels