Gw-instek GRC-1201 (GSG-120/122 Remote Controller) Manuel d'utilisateur télécharger pdf (Page 6)

GRC-1201 User Manual

 























 







GRC-1201 User Manual

CONNECTION METHOD

Turn off the POWER SW of the signal generator , set the connector at

the tip of the GRC1201 cable to the REMOTE connector on the rear

panel of the signal generator , and turn on the POWER SW.

If information is not displayed correctly , turn off the POWER SW and

turn it on again.

OPERATON METHOD

(A) Each time the higher digit or key or lower digit

or key in MEMORY block is pressed, the value of the

relevant digit of memory address increases or decreases by 1.

(B) The lower digit and keys in MEMORY block and

MOD, PILOT keys in MOD block have the same functions as those

keys on the signal generator front panel.

signal generator and the PILOT , MOD indicator in the MOD block

of GRC1201 shows the same status as that on the signal generator.

(D) Data must be written into memory in advance by use of keys on

signal generator. (See section 4-5(2) of GSG120/122 Operation

Manual.)

(E) Before using the rotary knob . move the cursor to the item to be

modified by use of the , , and key(s).

(F) If the LOCK key is pressed. the data value cannot be changed by

turning the rotary knob; that is . the data is fixed at the value

specified immediately before the LOCK key was pressed.

(G) The and KEYS in LEVEL block use to increase or

decrease the output levels (continuity).

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Gw-instek GRC-1201 (GSG-120/122 Remote Controller) Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Gw-instek GRC-1201 (GSG-120/122 Remote Controller)