Gw-instek GDM-8300 series Excel Add-in Operation Guide Manuel d'utilisateur télécharger pdf (Page 5)

SETUP

Connection

Before using the Excel Add-In you must set the baud rate for the DMM in the

USB menu. This configuration will be used when using the software to

connect to the DMM remotely.

Note: This Add-In cannot be used with the GPIB option.

1. Connection

1. Connect the rear panel USB B port on the DMM

to a USB port on the PC using a Type A to Type B

USB cable.

2. Configure the

DMM

2. Press MENU.

3. Go to I/O on level 1.

4. Go to USB on level 2.

5. Set the baud rate to an applicable rate.

6. Press Enter to confirm the baud rate settings.

7. Press EXIT to exit from the USB menu.

1 2 3 4 5 6 7 8 9 10 ... 18 19

Pas de commentaire

Gw-instek GDM-8300 series Excel Add-in Operation Guide Manuel d'utilisateur Page 5