Gw-instek GDS-3000 Series GUG-001, GPIB to USB adapter User Manuel d'utilisateur télécharger pdf (Page 6)

GUG-001 User Manual

(Pollution Degree) EN 61010-1:2001 specifies pollution degrees and

their requirements as follows. The instrument falls under degree 2.

Pollution refers to “addition of foreign matter, solid, liquid, or

gaseous (ionized gases), that may produce a reduction of dielectric

strength or surface resistivity”.

 Pollution degree 1: No pollution or only dry, non-conductive

pollution occurs. The pollution has no influence.

 Pollution degree 2: Normally only non-conductive pollution

occurs. Occasionally, however, a temporary conductivity caused

by condensation must be expected.

 Pollution degree 3: Conductive pollution occurs, or dry, non-

conductive pollution occurs which becomes conductive due to

condensation which is expected. In such conditions, equipment

is normally protected against exposure to direct sunlight,

precipitation, and full wind pressure, but neither temperature

nor humidity is controlled.

Storage

environment

 Location: Indoor

 Storage Temperature: -10°C~60°C, no

condensation-

 Relative Humidity: 93% @ 40°C

65% @ 41°C ~60°C

Disposal

Do not dispose this instrument as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased. Please make sure

discarded electrical waste is properly recycled to

reduce environmental impact.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Pas de commentaire

Gw-instek GDS-3000 Series GUG-001, GPIB to USB adapter User Manuel d'utilisateur Page 6