Gw-instek GSP-827 Programming Manual Manuel d'utilisateur télécharger pdf (Page 2)

GSP827 Command List

Note in examples

1. Returning message “OK” returns only for the software version V1.02 and below. (V0.94, V1.01).

2. Characters in italics represent the returning messages.

3. “^” means “space”.

4. Delay time is recommended only for reference. It could differ from different application.

5. All the Marker ( MEAS:MARK:xxxx) and Peak (MEAS:PEAK:xxxx) functions are available only for MM mode ON.

Command List <parameter> Delay

(ms)

Description

Parameters

(The unit is not case sensitive).

Example

(^ :space)

*CLS 300

Clear Status Command

*CLS

*ESE 300 Standard Event Status Enable

Command

*ESE

*ESE? 500

Standard Event Status Enable Query

*ESE?

*ESR? 500 Standard Event Status Register

Query

*ESR?

*IDN? 500 Identification Query *IDN?

*OPC 300 Operation Complete Command *OPC

*OPC? 500 Operation Complete Query *OPC?

*RST 300 Reset Command *RST

*SRE 300

Service Request Enable Command

*SRE

*SRE? 500 Service Request Enable Query *SRE?

*STB? 500 Read Status Byte Query *STB?

*TST? 500 Self-Test Query *TST?

*WAI 300 Wait-to-Continue Command *WAI

MEASure FREQuency CENter <value><unit

500 Set the center frequency Range: From 9k to 2.7GHz. Unit can be kHz,

MHz and GHz

MEAS:FREQ:CEN^100000^kHz

MEASure FREQuency CENter? 500 Query the center frequency in kHz Reply: <value> <unit> MEAS:FREQ:CEN?

100000.0^kHz

MEASure FREQuency STart <value><unit

500 Set the start frequency Range: From 9k to 2.7GHz. Unit can be kHz,

MHz and GHz

MEAS:FREQ:ST^50^MHz

MEASure FREQuency STart? 500 Query the start frequency in kHz MEAS:FREQ:STP?

100000.0^kHz

1 2 3 4 5 6 7 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

Gw-instek GSP-827 Programming Manual Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Gw-instek GSP-827 Programming Manual