Gw-instek PST series Programming Manual Manuel d'utilisateur télécharger pdf (Page 10)

PST & PSS & PSH SERIES PROGRAMMABLE POWER SUPPLY

PROGRAMMER MANUAL

⎯ 17 ⎯

Table 4: Miscellaneous Commands

*IDN? Returns instrument identification.

*OPC Reports when operation is complete by setting

the Operation Complete bit in SESR.

*OPC? Reports when operation is complete. Same as

*OPC except returns a 1 to the output queue

and dose not set the SESR bit.

*RCL ★Recall the setting data from the memory

which previous saved.

*RST Resets the protection levels and states, resets

the current and voltage levels to zero, sets the

output off, and sets memory section to 00.

*SAV ★Saves the setting data to memory.

*TST? Initiates internal self-test and reports results.

*WAI Wait to continue. This command forces

sequential operation of commands. This

command is required by IEEE-488.1-1987.

The power supply, however, forces sequential

operation of commands by design.

:SYSTem:AUTO:CYCLe

<NR1>

★Set number of times of execution.

:SYSTem:AUTO:CYCLe ? ★Query the setting of the number of times of

execution.

PST & PSS & PSH SERIES PROGRAMMABLE POWER SUPPLY

PROGRAMMER MANUAL

⎯ 18 ⎯

:SYSTem:AUTO:DELay

<NR1>

★ Set the delay time under the current

responding memory status.

:SYSTem:AUTO:DELay ? ★Query the setting of the delay time under

the current responding memory status.

:SYSTem:AUTO:END

<NR1>

★ Set the end memory section for auto

execute continuously.

:SYSTem:AUTO:END ? ★Query the end memory section for auto

execute continuously.

:SYSTem:AUTO:STARt

<NR1>

★ Set the start memory section for auto

execute continuously.

:SYSTem:AUTO:STARt ? ★Query the start memory section for auto

execute continuously.

:SYSTem:AUTO:STATe

★Sets Auto sequence on or off.

:SYSTem:AUTO:STATe ? ★Returns Auto Sequence mode on or off.

:SYSTem:ERRor ? Read the next item from the error/event

queue.

:SYSTem:MEMory? ★Query the last memory location

:SYSTem:VERSion? Returns the SCPI version level.

Remark: The mark “★” means the PSS and PSH do not have the

function.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Gw-instek PST series Programming Manual Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Gw-instek PST series Programming Manual