Gw-instek PSW-Series Programming & Command manual Manuel d'utilisateur télécharger pdf (Page 31)

REMOTE CONTROL

Configure GPIB Interface

To use GPIB, the optional GPIB to USB (GUG-001) adapter must be

used. The GPIB to USB adapter must be connected before the PSW

is turned on. Only one GPIB address can be used at a time.

Configure GPIB

1. Ensure the PSW is off before proceeding.

2. Connect the USB cable from the rear panel

USB B port on the PSW to the USB A port on

the GPIB to USB adapter.

3. Connect a GPIB cable from a GPIB controller to

the GPIB port on the adapter.

Type B plug for

PSW series

Type A plug

From

computer

GUG-001

4. Turn the PSW on.

5. Press the Function key to enter the

Normal configuration settings.

Page 21

Set the following GPIB settings:

F-22 = 1

Set the rear panel USB port to

GPIB-USB (GUG-001)

F-23 = 0~30

Set the GPIB address (0~30)

GPIB constraints

 Maximum 15 devices altogether, 20m cable

length, 2m between each device

 Unique address assigned to each device

 At least 2/3 of the devices turned On

 No loop or parallel connection

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 117 118

Pas de commentaire

Gw-instek PSW-Series Programming & Command manual Manuel d'utilisateur Page 31