Gw-instek GDS-800 Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 16)

GDS-806/810/820/840 Programming Manual

For the actual value of the parameter type <Boolean>, you have to enter 0 instead

of “OFF” or enter 1 instead of “ON”.

The following example includes both the header and a value for the parameter type:

:TRIGger:NREJ 0

Parameter values that appeared in this manual are often separated by a vertical

line. This vertical line means the same thing as the word "or," For example, values

for the parameter <Boolean> are

0|1

This is the same thing as saying "0 (off) or 1 (on)" Any single value is a valid

parameter.

Message Terminator and Message Separator

In accordance with IEEE 488.2 standard, this oscilloscope accepts any of the

following message terminators:

z LF

END Line feed code (hexadecimal 0A) with END message

z LF

Line feed code

z <dab>

END

Last data byte with END message

These terminators are compatible with most application programs.

A semicolon separates one command from another when the commands appear on

the same line.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 88 89

Pas de commentaire

Gw-instek GDS-800 Series Programming Manual Manuel d'utilisateur Page 16