REMOTE INTERFACE
241
Select Sweep
Time
Select the sweep
trigger source
Select the marker
frequency
5. Choose the sweep time using the
SOURce[1|2]:SWE:TIME command.
6. Select an internal or external sweep trigger
source using the SOURce[1|2]:SOUR
command.
7. To output a marker frequency from the
trigger out, use The
SOURce[1|2]:MARK:FREQ command. To
enable marker frequency output, use the
SOURce[1|2]:MARK ON command.
The marker frequency can be set to a value within
the sweep span.
Sets or disables Sweep mode. By default Sweep is
disabled. Sweep modulation must be enabled
before setting other parameters.
Any modulation modes or Burst mode will be
disabled if sweep mode is enabled.
SOURce[1|2]:SWEep:STATe {OFF|ON}
Sweep mode is currently enabled.
Commentaires sur ces manuels