Gw-instek APS-1102 User Manual Manuel d'utilisateur télécharger pdf (Page 251)

9.1 Output

APS-1102 Programmable AC/DC Power Source 9-3

 Output terminals

Terminal block with M4 screws (rear panel)

AC receptacle (universal type, front panel)

Note: Use AC receptacle for AC (0 V AC to 250 V AC). When DC is included, use screw terminal

block on rear panel.

 Rated output

100 V range: 100 Vrms (AC) / 100 V (DC)

200 V range: 200 Vrms (AC) / 200 V (DC)

 Output voltage settings

(When signal source mode is internal mode or internal + external mode, no load)

Note: The AC settings (peak value)+ DC setting that can be set are within the voltage setting limit

range.

100 V range: 0.0 to 140.0 Vrms

200 V range: 0.0 to 280.0 Vrms

Setting resolution: 0.1 Vrms

Setting accuracy: ±(0.5% of set value +0.6 Vrms): 100 V range

±(0.5% of set value +1.2 Vrms): 200 V range

(AC mode, 50 Hz, 23 ±5°C)

100 V range: 200.0 V to +200.0 V

200 V range: 400.0 V to +400.0 V

Setting resolution: 0.1 V

Setting accuracy: ±(  0.5 % of set value  + 0.8 V): 100 V range

±(  0.5 % of set value  + 1.6 V): 200 V range

(AC+DC mode, 0 V AC setting, 23 ±5°C)

 Maximum output current

100 V range: 10 Arms (AC) / 10 A (DC)

200 V range: 5 Arms (AC) / 5 A (DC)

Note 1: For the AC 100 V input system, the limit on the maximum output power may cause a

reduction in the maximum output current.

Note 2: At or above the rated output voltage, the limit on the maximum output power reduces the

maximum output current.

Note 3: When output frequency is 40 Hz or lower, or it is 400 Hz or higher, the maximum output

current may decrease.

Note 4: The RMS value for AC + DC is within the maximum output current.

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 264 265

Pas de commentaire

Gw-instek APS-1102 User Manual Manuel d'utilisateur Page 251