Gw-instek APS-1102 User Manual Manuel d'utilisateur télécharger pdf (Page 97)

4.4 Using the Sequence Function

APS-1102 Programmable AC/DC Power Source 4-33

Table 4-10. Setting Items in PROGRAM Screen (3/3)

Setting Name Item Operation

STEP TERM Step end

Sets operation after end of step.

Select one of the following three options.

 CONT: Sequence continuation

 STOP: Change to Idle mode

 HOLD: Change to Hold mode

JUMP STEP Jump step

Sets the step number to jump to after the end of the

previous step.

 0: Continue to next step number

 1 to 255: Jump to specified step number

JUMP NUM Jump times

Sets the number of times to execute the jump operation

specified by JUMP STEP.

 0: Unlimited jumps

 1 to 999: Specified number of jumps

BRANCH0 Branch step 0

Sets the step number to jump to when trigger input has

occurred.

Two types of branch steps can be set: BRANCH0 and

BRANCH1.

[Command example]

When a STOP is set after a small number of sweeps at the

jump destination step, it enables uses where there is a

safe region for saving data if necessary.

 0: Branch disabled

 1 to 255: Jump to specified step number

BRANCH1 Branch step 1

The operation steps for each of the setting items in the PROGRAM screen are described below.

 Operation step <1>

The settings for step number (STEP), step time (TIME), DC voltage (DC VOLT, AC+DC mode only),

AC voltage (AC VOLT), AC frequency (FREQ), phase (PHS), step end phase (STOP PHS), jump step

(JUMP STEP), jump times (JUMP NUM), and branch (BRANCH0/BRANCH1) are made by entering

numerical values for various items in the order described below.

The example described below is when entering the setting for step time (TIME).

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 264 265

Pas de commentaire

Gw-instek APS-1102 User Manual Manuel d'utilisateur Page 97