Gw-instek LCR-800 Series Manuel d'utilisateur télécharger pdf (Page 58)

INTERACE

115

Pin11

/O_BIN_11 Go, Assigned BIN 11

Pin12

/O_BIN_12 Go, Assigned BIN 12

Pin13

/O_BIN_13 Go, Assigned BIN 13

Pin14

/O_S_OVER No-Go/D or Q fail

Pin15

/O_P_OVER RLC FAIL(O)

Pin16

GND GROUND

Pin17

VCC VCC

Pin18

GND GROUND

Pin19

/O_P_HI RLC FAIL(O)

Pin20

/O_P_LO RLC FAIL(O)

Pin21

/O_S_REJ No-Go/D or Q fail

Pin22

/O_INDEX Data acquisition over,

OK to remove DUT(O)

Pin23

/O_EOM End of Test(O)

Pin24

/I_E_TRIG Start Measurement(I)

Pin25

/I_K_LOCK Panel Lock

LCR-800 User Manual

116

Signal Overview

Background

The signal overview section describes the

functions and the overall characteristics of the

signals used in the handler interface.

Parameter Output Signals

/O_INDEX

The Index signal will become low

when the Analog measurement time

has completed. When the Index

signal is low, the test component can

be replaced with the next

component. The signal goes high

when the next trigger is active.

/O_BIN_1 ~

/O_BIN_13

The Bin Go/No-Go signals go active

low when a successful comparison

has been made. For example if a

component is assigned to Bin_1,

/O_BIN_1 signal goes low until time

T4. All the remaining signals

(/O_BIN_2~/O_BIN_13) remain

high.

/O_P_HI

When the primary measurement is

higher than the MAX limit, O_P_HI

will go low until time T4.

/O_P_LO

When the primary measurement is

lower than the MIN limit, O_P_LO

will go low until time T4.

/O_P_OVER

When the primary measurement is

higher or lower than the MAX/MIN,

O_P_OVER will go low until time T4.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 71 72

Commentaires sur ces manuels

Pas de commentaire